Top 10 typical forklift crashes ， forklift procedure must focus on these matters ！.

Top 10 typical forklift crashes ， forklift procedure must focus on these matters ！.

Blog Article

Don't undervalue the forklift at work. If the operation is not good, there will certainly be significant crashes in mins, and there are many accidents involving forklifts.

Case 1: The forklift cargo blocked the chauffeur's sight, and the person in front could not be found, resulting in a rolling accident.
Case 2: In order to keep the equilibrium of the forklift when raising hefty products, the workers used their body weight as the counterweight, which almost caused casualties.
Instance 3: The size of the forklift freight surpasses the allowable width of the course and holds on the roadside rack, which practically causes an accident.
Instance 4: Forklift is speeding up and rolls over during a turn.
Instance 5: The forklift vehicle driver did not observe the pedestrian, and the pedestrian did not observe the forklift.
Case 6: The forklift raises the employees illegally, the forklift driver does not put on the safety belt, the forklift lifter falls and the driver is squashed when the forklift rolls over.
Case 7: The forklift vehicle driver did not wear a safety belt and dropped from the car when it surrendered and was crushed.
Forklift operation need to take notice of these matters ：.

Start.
1. Prior to starting, observe the environments, and after verifying that there are no barriers that impede the safety of driving, beep the horn first and afterwards start.
2. For lorries with hydraulic (air pressure) brakes, the brake hydraulic stress (air pressure) scale need to be safe prior to beginning.
3. When the forklift starts with a lots, the chauffeur should first validate that the tons is secure and reputable.
4. The start needs to be slow-moving and stable.

Driving.
1. When driving, the elevation between the bottom end of the fork and the ground must be kept at 300mm-400mm, and the mast needs to be tilted backwards. .
2. Do not raise the fork too high when driving. When going into and leaving the job site or while driving, beware that there will certainly be no obstacles in the sky. When the tons is taking a trip, the fork should not be increased expensive, which will impact the security of the forklift. .
3. After dumping, the fork ought to be reduced to the regular driving position before driving. .
4. When transforming, if there are pedestrians or lorries close by, the driving signal ought to be provided initially. High-speed doglegs are prohibited. High-speed sharp turns will trigger the lorry to shed lateral stability and tip over. .
5. When the forklift is downhill, it is strictly prohibited to switch off the fire and slide, and it is restricted to brake suddenly while driving with loads unless there are special conditions.
6. When the forklift is running, it has to obey the traffic rules in the factory and should keep a specific security distance from the car in front. .
7. When the forklift is running, the tons should be in the lowest setting that does not hinder the driving, and the gantry should be properly tilted back. The load will not be elevated other than when piling or packing. .
8. The elevation of the tons should not block the driver's sight. In unique conditions, when the thing impacts the forward vision, drive at a low speed when reversing.
9. It is restricted to activate the ramp, neither to drive across the ramp. .
10. The safe driving rate of the forklift in the manufacturing facility location is 5 km/h, and it should drive safely at a reduced rate when going into the production workshop area. .
11. When the forklift is raised, lifted or driven, it is forbidden for personnel to depend on the fork to hold products and play a balancing role. .
12. If troubles are discovered, they will be fixed and reported in a prompt way, and they will certainly never ever operate with illnesses or hide them.

packing and unloading.
1. When fork-loading things, the distance between both forks ought to be readjusted as required to make the lots of both forks balanced and not manipulated, and one side of the item need to protest the rack. .
2. It is restricted to work with a solitary fork or utilize a fork top or draw. In special circumstances, safety and security warning signs have to be set up to advise surrounding pedestrians. .
3. In the process of filling and discharging things, the forklift should be stopped with the brake. .
4. The speed of the lorry ought to be slow-moving and consistent. Be careful not to roll the wheels on the dunnage, so as not to stretch the rolled things and harm individuals. .
5. When using a fork to fork the goods, the fork must be as deep as possible under the tons, and it needs to be noted that the fork idea should not touch various other items or items. The lots should be supported with marginal back tilt of the gantry to ensure that the lots does not slide backwards. The pole can be slanted forward somewhat when the lots is lowered to allow for simple positioning of the load and extraction of the forks. .
6. It is prohibited to fork items at high speed and hit hard items with the fork head. .
7. When the forklift is functioning, it is restricted for individuals to loaf the fork, so as to stay clear of the collapse of the goods and injure people. .
8. Overwhelming is prohibited, and it is prohibited to use forks to lift workers to participate in high-altitude procedures to avoid high-altitude dropping crashes. .
9. It is not enabled to utilize the brake inertia to slide, place, round or roll items. .
10. It is not permitted to use forks to pick, turn pallet dump.

Leaving .
1. It is forbidden to leave the forklift when the items on the fork impend. Before leaving the forklift, you must dump the goods or lower the fork frame.
2. Draw the parking brake manage to dead or depress the parking brake switch.
3. The engine is shut off and the power is cut off. (Except for unique circumstances, such as the vehicle driver does not leave the car's view and does not surpass 1 minute).
4. Get rid of the secret. .

Forklift Operation Precautions.
1. Before and after the forklift operation, the appearance ought to be checked, and gas, lubing oil and Stand-on Electric Pallet Stacker air conditioning water need to be included.
2. Examine the safety efficiency of starting, running and braking.
3. Inspect whether the lights and horn signals are total and reliable.
4. During the operation of the forklift, examine whether the pressure and temperature level are regular.
5. After the forklift is running, the external leak should also be examined and the seals should be replaced in time.

Forklift Safety Operation Specifications.
1. You need to examine before leaving the automobile;.
2. When you come across someone before you during driving, you must send out a signal at a distance of 5 m;.
3. The driving speed in the manufacturing facility does not exceed 5 km/h;.
4. When driving, the low point of the freight ought to be 0.3 m ~ 0.4 m above the ground;.
5. The turning must not be too sharp Electric Forklift Truck for Warehouse to prevent the propensity of " cost-free turning";.
6. Running up and down the incline must be slow-moving and uniform, and no switching on the incline is allowed.
7. Do not drive throughout the gradient. When the gradient is higher than 10%, the automobile must be driven backwards when declining;.
8. When the forklift employees lug the goods and progress, if they experience huge or hefty goods and most likely to the motorist's line of vision, they need to take the turning around workout
.
The "Eight Prohibitions" ought to be adhered to in the operation.
1. Single fork procedure is not enabled.
2. It is not permitted to lift the goods for far away driving.
3. It is not permitted to grab the goods by handing over the pallet with the fork.
4. It is not permitted to straight shovel chemicals, flammables and various other harmful chemicals with forks.
5. It is not permitted to make use of inertia force to get the goods.
6. It is not permitted to make use of braking force to expatriation round or easy-to-roll things.
7. It is not permitted to bring individuals to work on the pallet or fork, and it is strictly prohibited to stand under the fork after the fork is elevated.
8. Do not drive side to side on inclines
.
Auto parking is not allowed under the following conditions.
1. Curves, slim roads, train crossings;.
2. Areas with a longitudinal slope higher than 5%.
3. When there is an barrier on one side of the roadway, the contrary side of the area with the exact same size as the challenge ought to be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844